Contact: info@pavlin.si
Archive for the ‘Printed parts’ Category.
I broke the original housing for GoPro Session (the smallest GoPro). Then I designed more bulky one, suitable for 3D printing.
Here is the OnShape project.
and 3D printed part…
Please send email for STL files.
Final version with holder for quick release gooseneck:
I recently found interesting project https://www.telraam.net/ It’s an open source project where a Raspberry Pi with camera counts traffic passing by (pedestrians, bicycles, cars and other heavy vehicles). The device is (as stated by authorts) “mounted on the inside of an upper-floor window with a view over the street. To send the traffic count data straight to the central database, the device needs a continuous Wi-Fi connection to the internet.”
I placed one in my home on the window and it started counting some day after installation.
Next I wanted to install one in my remote location, where I have internet for other IoT purposes. There is no “upper-floor window”, which means I should place my raspberry and camera outside. Here is how I did it…
Continue reading ‘Outdoor housing for Telraam Traffic counting camera’ »The solar radiation shield is a low cost DIY device to protect temperature, relative humidity and other sensors from the weather, while shielding them from the sun for highest accuracy. Provided here are instructions and files. It require some CNC machinig, but then it could be assembled in minutes. It is made from plant pot saucers.
I designed simple two pice toothbrush stand for 8 brushes. In our large family it is sometimes hard to track the toothbrushes only by color. I decided to put this issue in order by ordering the brushes with two simple 3D printed parts. Front one has magnets for removing from the shelf when needed due to cleaning.
Holder in place used in bathroom
Model files are in this file: STEP, PARASOLID and Solidworks
3D model with bathroom shelf
Two pieces for 3D printing
Two magnets (12mm dia, 2mm thick) are attached with epoxy into front holder. Add two more magnets and attach with epoxy to the uderside of the shelf as shown in the first picture.After curing/drying the holder can be removed and cleaned.
Rear holder is attached with two side self adhesive.
Grabcad project: https://grabcad.com/library/toothbrush-holder-8
Please share if you like the idea.
There was no3D model for RAK811 breakout board with GPS tracker, so I made it from the drawings. I added plastic housing to be used with velcro straps. I prepared two models, one with only RAK811 and small LiPo battery and second one, 4mm higher with enough space for additional PCB with custom electronics. Enjoy.
Higher version with additional PCB
Lower version without additional PCB
Base is same for both versions.
This is housing for R.Pi camera V2 with LED illumination.
Camera housing
It is 3D printable housing and PCB with 9 IR LEDs with enable.
Branko, one of the famous experts for old(ish) radio devices designed magnetic loop antenna, which can be 3D printed. Here are complete instructions in german language:
Loop Antenne aus dem 3D-Drucker
Some photos of first “serious” parts made with new all metal extruder and CNC 3D printer.
All prints are made with ABS, without heated bed! Part scale: diameter is 10mm.
Slovenski opis (in Slovenian language)